The bad: I'm guessing it has a tight chamber. Damn tight. Ran like a top with the factory S&B stuff above. Was a nasty single shot with reloads.
ETA: Quick testing with a case gauge shows the fired cases to be shorter than the unfired reloads to the shoulder. Fun. I wonder if a bolt swap will even them out? I have a third bolt to add into the mix- maybe it would make the other rifle smaller chamber smaller, too? All headspaced fine with the gauges.
No comments:
Post a Comment
Welcome to my little hole. Comments on any post over 14 days old get held in moderation, until I notice my emails. Anything that really annoys me may get moderated. Obvious Trolls are asked to be obvious- 'tis always nice when the target marks itself.